An increased interest in absorption chillers has been observed [1] because these systems can utilize solar, geothermal and biomass energy sources, but also because they are quiet, vibration-free, require little maintenance and are ecological [2]. Instead of a compressor system, which uses electricity, an absorption cooling system, using renewable energy and kinds of waste heat energy, may be used for cooling. This paper presents the simulation of a single stage solar absorption chiller operating with an ammonia–water mixture under steady state conditions. This simulation is based on heat and mass balances for each component. The heat and mass transfers in the absorber, the condensation of binary vapor of ammonia–water in the condenser and a thermosyphon desorber placed under the purification column were modeled. The numerical model was compared and validated with experimental data obtained with a solar absorption chiller. The calculated results agree well with experimental data. Simulations based on experimental data were used to predict the temperature and concentration profiles in each heat exchanger. A parametric study was conducted to investigate the effect of evaporator and desorber temperature on the absorption chiller's performance. The COP decreases by 25% with a decrease of 10 °C in evaporator temperature and the COP increases by 4% with an increase of 10 °C in desorber temperature.
