Lignite-based polygeneration system has been considered as a feasible technology to realize clean and efficient utilization of coal resources. A newly polygeneration system has been proposed, featuring the combination of a 2×300MW circulating fluidized bed (CFB) power plant and atmospheric...

Promoting the nitrogen oxide (NOx) absorption step is the major challenge for simultaneous removal of sulfur dioxide (SO2) and NOx in wet flue gas desulfurization. This paper studied NOx absorption and absorption product formation in limestone slurry. The effect of CaCO3 concentration, NOx...

In order to give a better understanding for the selection of suitable absorbents for the novel membrane vacuum regeneration technology (MVR) which has the potential to reduce CO2 energy requirement by utilizing the waste heat or low-grade energy, an experimental study to determine the...

Agglomeration is a major problem in straw combustion in a fluidized bed. This paper presents the results of rice straw combustion experiments carried out under different operating conditions in a bubble-fluidized bed (BFB). The influences of bed material size and type, feeding mode, temperature,...

Oscillating flows have fundamental effects on the heat and mass transfer of Stirling engines and gas springs. A complex velocity model was proposed to describe the fully-developed laminar oscillating flow through introducing complex functions and simplified control equations. The maximum...

Using the technology of spectral selectivity to integrate different solar power generators in a hybrid system is a feasible way to improve the optical-electric efficiency. This paper presents an 82-layer broadband optical interference thin-film filter matching with crystalline silicon...

Molecular distillation was used to separate bio-oil into a light fraction, a middle fraction and a heavy fraction. The chemical composition of the three fractions and the crude bio-oil was analyzed by gas chromatography coupled with mass spectrometry (GC-MS). The diversity of the components...

This paper attempts to categorize solar stills into six sorts based on the design guidelines used in each device. The properties of these design guidelines are detailed and evaluated from the angle of enhancing the productivity of solar stills. Preferred design guidelines are recommended for...

A solid-particle solar receiver was proposed to convert concentrated solar beams into heat for high-temperature thermal storage in a two-stage dish system. Spherical Xe-arc lamps were used to simulate a solar light source. The performances of this receiver under a Xe-arc lamp array system were...

The continuous increase in energy demand and the growing attention on global warming worldwide have aroused great research interest in a novel near zero emission energy utilization system which is based on CaO sorption enhanced gasification. This paper presents the experimental results of...