Two models are proposed to roughly approximate the observed behavior of the amplitude of the drilling torque in the BTA-deep-hole-drilling process. It is schown that these models are closely connected.

One serious problem in deep-hole drilling is the formation of a dynamic disturbance called spiralling which causes holes with several lobes. Since such lobes are a severe impairment of the bore hole the formation of spiralling has to be prevented. Gessesse et al. (1994) explain spiralling by the...

In this paper we present how statistical experimental design, time series analysis and non-linear dynamic models have been applied to gain a deeper insight into BTA-deep-hole drilling process. BTA-deep-hole drilling process is used to produce long holes of a length to diameter ratio larger than...

Thirteen Stylized Facts of the german economy are studied with different descriptive statistical methods. The results of this study are considered with respect to other results from Project B3 Multivariate Bestimmung und Untersuchung von Konjunkturzyklen.

We propose multivariate classification as a statistical tool to describe business cycles. These cycles are often analyzed as a univariate phenomenon in terms of GNP or industrial net production ignoring additional information in other economic variables. Multivariate classification overcomes...

In this paper business cycles are considered as a multivariate phenomenon and not as a univariate one determined e.g. by the GNP. The subject is to look for the number of phases of a business cycle, which can be motivated by the number of clusters in a given dataset of macro-economic variables....

When a process is dominated by few important frequencies the observations of this process can be modelled by a harmonic process (Bloomfield (2000)). If the amplitudes of these dominating frequencies vary over time their dominance may not be apparent during the whole process. To discriminate...

Deep hole drilling methods are used for producing holes with a high lengthto- diameter ratio, good surface finish and straightness. The process is subject to dynamic disturbances usually classified as either chatter vibration or spiralling. In this work, we propose to monitor the BTA drilling...

Deep hole drilling methods are used for producing holes with a high length-to-diameter ratio, good surface finish and straightness. The process is subject to dynamic disturbances usually classified as either chatter vibration or spiralling. In this paper, we will focus on the application and use...

Two models are proposed to roughly approximate the observed behavior of the amplitude of the drilling torque in the BTA-deep-hole-drilling process. It is schown that these models are closely connected.