The paper deals with the production of could drawn precision seamless steel tubes with three-drawn and two-drawn single-run technology. The aim of experiment is to verify the possibility of drawing rolled tubes of size ∅ 70 × 6.3 mm (material E355) with three-draw single-run technology...

Silver streaks on injected thermoplastic parts are the undesirable features, considered as a visual surface defect. If they appear, elimination of this technological problem can be very difficult, especially in case the cause of their occurrence is not actually known. In this study, the detailed...

Silver streaks on injected thermoplastic parts are the undesirable features, considered as a visual surface defect. If they appear, elimination of this technological problem can be very difficult, especially in case the cause of their occurrence is not actually known. In this study, the detailed...

The submitted article discusses rotational moulding technology and filled plastics. For testing, linear low density polyethylene filled with talc was used. The materials tested varied way of mixing the filler into the polymer. For the prepared samples were evaluated by tensile, elongation, melt...

The fibre orientation in short fibre reinforced thermoplastics depends on injection moulding technology parameters. The aim of this paper is to propose possibilities for comparing fibre orientation of the real sample and the result from simulation software. Fibre orientation of selected...

Study describes principles of diesel effect creation during thermoplastic injection moulding as a consequence of wrong injection conditions and poor venting system design. On real example, study shows sequence of all steps to eliminate this sort of material degradation with minimal costs in...

Study describes principles of diesel effect creation during thermoplastic injection moulding as a consequence of wrong injection conditions and poor venting system design. On real example, study shows sequence of all steps to eliminate this sort of material degradation with minimal costs in...

The fibre orientation in short fibre reinforced thermoplastics depends on injection moulding technology parameters. The aim of this paper is to propose possibilities for comparing fibre orientation of the real sample and the result from simulation software. Fibre orientation of selected...