Simulation of blast waves by using mapping technology in EUROPLEXUS

Finite element or finite volume simulations for the development of blast waves by using a model for the explosion of the solid itself need very fine meshes in the explosive and in the zone around the explosive. Structures may have a long distance to the source of the explosive. This leads often to very big meshes with many elements. The explosive is meshed often only coarse and therefore the results are not very accurate. There are several possibilities to deal with this problem. Large 3D calculations with a solid TNT model using a JWL-equation can be used but they are more effective when the results of one finer mesh could be mapped in a coarser mesh after some calculation steps. When the blast wave reaches a certain distance to the charge, the small elements inside the charge are not needed any more since the pressure ratio is decreased strongly. These small elements results in very small time steps for the full model. The report shows the implementation of the mapping algorithm in EUROPLEXUS and several validation tests of the method.